• Lindapter M10 Type B Medium Zinc Plated
  • B10M 1
  • B10M 2
  • B10M 3

Lindapter M10 Type B

  • Brand: Lindapter
From £340.00 ex. VAT per 100From £408.00 inc. VAT per 100


Type B Girder Clamp

Standard girder clamp, with flat top, used to quickly connect steel beams with parallel / flat flanges and resist moderate tensile loading.


The Type B girder clamp is used to achieve a fast steelwork fixing connection between two steel beams and is often used in a pair with Type A clamps. It has a flat top to allow the bolt head or nut to rotate on a hardened washer and can also be used with studs, tie rods or J-bolts. The skirt on the underside of the clamp abuts the edge of the beam flange and prevents the clamp rotating during installation. Type B girder clamps can also be used on their own if one piece of the steelwork has been pre-drilled.

Features & Benefits

  • Flat top allows the bolt head or nut to rotate on a hardened washer.
  • Ideal for parallel flanges.
  • Supports up to 78.8kN tensile in a four-bolt configuration.


  • CE Marked
  • Lloyd’s Register Approved
  • TÜV Nord Approved
  • Manufactured to ISO9001 and ISO14001

Tail Lengths & Packing Pieces

The clamp is available in three tail lengths, Short, Medium and Long and can be used with Lindapter packing pieces to increase the clamping range. Choose the correct combination of tail length and packing pieces to suit a specific flange thickness. Download datasheet below for selection table.

Location & End Plates

These plates ensure the clamps and bolts are located in the correct position relative to the supporting steelwork. Location plates are simple fabricated items designed to sit between the two sections to be clamped together to ensure the bolts are fixed at the correct centres. End plates are simple fabricated items that are pre-welded to support frames, bracket or sections, allowing connection to the supporting structure with standard Lindapter clamps. Download datasheet below for further information.


  • Manufactured from malleable iron to BS EN 1562.
  • Available with zinc plated or hot dip galvanised finish.
  • Reaction to fire: A1 (Steel)
  • Durability and corrosion protection:

Corrosivity Class

Galvanised Steel

Electroplated Steel


More than 50 years

More than 20 years


More than 50 years

More than 5 years


More than 20 years

Not suitable

Product Options

Part CodeNameStockPrice (per 100)QtyBolt 8.8 ZTensile / 1 Bolt (kN)Slip / 2 Bolts (kN)Tightening Torque* (Nm)Y (mm)X (mm)Tail Length (mm)T (mm)Width (mm)Finish
B10MLindapter M10 Type B Medium Zinc Plated

Live Stock Unavailable

In Stock

Available to Order

£340.00 ex. VAT £408.00 inc. VAT

M101.5-20201151026Zinc Plated
Sorry, this item is currently out of stock.
We currently hold [remaining-stock] units of this item in stock. The remainder will be put on back order.
You cannot order more of this item than we currently hold in stock.
You must order at least [min-order-qty] of this product.
You must order at least [min-order-qty] of this product. We currently hold [remaining-stock] in stock. The remainder will be put on back order.

This site uses cookies. By continuing your visit, you accept their use as set out in our Cookie Policy. OK